kk2 receiver hookup

Judith Soto, 34 years old


About me:
Menu FliteTest Forums. Log in Register. Search titles only. Search Filters. Forums New posts Search forums.

The 1 problem encountered by DSM fliers: Unlike PCM, where servos get "crunchy" at voltages as low as 2. New QuickConnect software kk2 receiver hookup restoration of your radio link the instant voltage is restored. Why using multiple remote receiver is important. Having additional receivers increases your chance of having a perfect RF link, pure and simple. More is better. And when you have correct polarization see DO polarize when possible things get even that much better.

There are so many setup guides, settings, and videos for the KK2. This is my first Flight Control Board. Step 1: Program a model in your transmitter and use Acro mode.
Interests:
More about kk2 receiver hookup:
Remember Me Forgot Password? Jan 02, , This guide also assumes that you have your Transmitter and Receiver all set up and bound. Use Google to search as there are TONS of videos and tutorials on all of the following steps and much more. Before installing flash the KK2. The USBasp will provide power so you can flash and program. Now go to Show Motor Layout and take note of the motor and esc numbers, configuration and which way the props spin that has been assigned to the motors.

Here is the KK2 setup video for the Tricopter V3. I noticed that I skimmed some areas a bit lightly when shooting the video, but I hope people still find it useful. NTM kV Props: Roll and Pitch gains: P Gain: Rudder gains: Stick Scaling: David, I have the KK2. All props rotate the same direction. Depends on you All up weight, and motor distance as well.

GitHub is home to over 31 million developers working together to host and review code, manage projects, and build software together. This custom firmware was written by RC for the KK2. This procedure is now a lot safer since ESC calibration no longer can be trigged by a damaged button. This is achieved by forcing you to temporarily activate the ESC calibration feature through the KK2 menu before using it. If any button is damaged you will not be able to navigate the KK2 menus without noticing it. The ESC calibration state is checked on every start-up and automatically disabled if it is found to be active.